GATE 2019 ME Set 2 · Question 64
In an orthogonal machining with a single point cutting tool of rake angle , the uncut chip thickness and the chip thickness are and , respectively. Using Merchant's first solution for the condition of minimum cutting force, the coefficient of friction at the chip-tool interface is _______ (round off to two decimal places).
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.54 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
First, calculate the chip thickness ratio :
The shear angle is obtained from:
Given rake angle :
According to Merchant's first solution for the condition of minimum cutting force:
where is the friction angle. Solving for :
The coefficient of friction at the chip-tool interface is:
Answer: 0.74
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2018 ME Set 1 · Q59An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is…
- GATE 2018 ME Set 2 · Q58Following data correspond to an orthogonal turning of a 100 mm diameter rod on a lathe. Rake angle: +15°;…
- GATE 2017 ME Set 2 · Q55In an orthogonal machining with a tool of 9° orthogonal rake angle, the uncut chip thickness is 0.2 mm. The…
- GATE 2016 ME Set 1 · Q34In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and…
- GATE 2016 ME Set 3 · Q59For an orthogonal cutting operation, tool material is HSS, rake angle is 22°, chip thickness is 0.8 mm,…
- GATE 2015 ME Set 1 · Q45An orthogonal turning operation is carried out under the following conditions: rake angle = 5°; spindle…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.