GATE 2020 ME Set 1 · Question 55
In a turning process using orthogonal tool geometry, a chip length of is obtained for an uncut chip length of .
The cutting conditions are: cutting speed = , rake angle = .
The shear plane angle is ________ degrees *(round off to one decimal place)*.
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.45 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
From the principle of volume constancy in orthogonal machining, the chip thickness ratio is related to the uncut chip length and cut chip length by:
The shear plane angle is given by Merchant's relation:
Given the rake angle :
Substitute these values into the formula:
Answer: 23.5
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2020 ME Set 2 · Q53A cylindrical bar with 200 mm diameter is being turned with a tool having geometry 0° - 9° - 7° - 8° - 15° -…
- GATE 2019 ME Set 1 · Q45In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting…
- GATE 2019 ME Set 2 · Q64In an orthogonal machining with a single point cutting tool of rake angle 10°, the uncut chip thickness and…
- GATE 2018 ME Set 1 · Q59An orthogonal cutting operation is being carried out in which uncut thickness is 0.010 mm, cutting speed is…
- GATE 2018 ME Set 2 · Q58Following data correspond to an orthogonal turning of a 100 mm diameter rod on a lathe. Rake angle: +15°;…
- GATE 2017 ME Set 2 · Q55In an orthogonal machining with a tool of 9° orthogonal rake angle, the uncut chip thickness is 0.2 mm. The…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.