GATE 2018 ME Set 1 · Question 59
An orthogonal cutting operation is being carried out in which uncut thickness is , cutting speed is , rake angle is and width of cut is . It is observed that the chip thickness is , the cutting force is and the thrust force is . The ratio of friction energy to total energy is ______ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.49 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
In orthogonal cutting, the chip thickness ratio is:
The chip velocity is related to the cutting velocity by:
The friction force along the tool-chip interface is determined from Merchant's circle:
Given , , and rake angle :
The friction power is , and the total cutting power is .
The ratio of friction energy to total energy is:
Answer: 0.44
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2018 ME Set 2 · Q58Following data correspond to an orthogonal turning of a 100 mm diameter rod on a lathe. Rake angle: +15°;…
- GATE 2017 ME Set 2 · Q55In an orthogonal machining with a tool of 9° orthogonal rake angle, the uncut chip thickness is 0.2 mm. The…
- GATE 2016 ME Set 1 · Q34In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and…
- GATE 2016 ME Set 3 · Q59For an orthogonal cutting operation, tool material is HSS, rake angle is 22°, chip thickness is 0.8 mm,…
- GATE 2015 ME Set 1 · Q45An orthogonal turning operation is carried out under the following conditions: rake angle = 5°; spindle…
- GATE 2015 ME Set 2 · Q62A single point cutting tool with 0° rake angle is used in an orthogonal machining process. At a cutting…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.