GATE 2022 ME Set 2 · Question 54
A straight-teeth horizontal slab milling cutter is shown in the figure. It has 4 teeth and diameter () of 200 mm. The rotational speed of the cutter is 100 rpm and the linear feed given to the workpiece is 1000 mm/minute. The width of the workpiece () is 100 mm, and the entire width is milled in a single pass of the cutter. The cutting force/tooth is given by , where specific cutting force , is the width of cut, and is the uncut chip thickness.
The depth of cut () is , and hence the assumption of is invalid. The maximum cutting force required is _________ *(round off to one decimal place)*.
GATE 2022 · Mechanical Engineering · Set 2 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The feed per tooth is given by:
For slab milling with depth of cut , the tooth immersion angle is:
The angular pitch between successive teeth is:
Since , at any given instant only one tooth is engaged in cutting.
The instantaneous uncut chip thickness is . Its maximum value occurs at :
The maximum cutting force required is:
Answer: 2.5
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2021 ME Set 1 · Q17In a machining operation, if a cutting tool traces the workpiece such that the directrix is perpendicular to…
- GATE 2021 ME Set 1 · Q18The correct sequence of machining operations to be performed to finish a large diameter through hole is
- GATE 2020 ME Set 1 · Q52A slot of 25 mm × 25 mm is to be milled in a workpiece of 300 mm length using a side and face milling cutter…
- GATE 2020 ME Set 2 · Q54There are two identical shaping machines S1 and S2. In machine S2, the width of the workpiece is increased…
- GATE 2019 ME Set 1 · Q25The length, width and thickness of a steel sample are 400 mm, 40 mm and 20 mm, respectively. Its thickness…
- GATE 2019 ME Set 1 · Q62In ASA system, the side cutting and end cutting edge angles of a sharp turning tool are 45° and 10°,…
Question from the official GATE 2022 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.