GATE 2014 ME Set 1 · Question 33
The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is . The turning was performed using depth of cut and feed rate. The specific cutting pressure (in ) is
- A
- B
- C
- D
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.23 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In an orthogonal turning operation, the uncut chip cross-sectional area is the product of the feed and the depth of cut :
The specific cutting pressure (also called specific cutting energy) is defined as the ratio of the main cutting force to the uncut chip area :
Answer: (B)
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2014 ME Set 1 · Q62During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the…
- GATE 2014 ME Set 3 · Q30A straight turning operation is carried out using a single point cutting tool on an AISI 1020 steel rod. The…
- GATE 2014 ME Set 3 · Q64Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool? P.…
- GATE 2014 ME Set 4 · Q33Better surface finish is obtained with a large rake angle because
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.