PARIXO GATE · ME Open the app

GATE 2014 ME Set 3 · Question 62

2 marksMultiple choiceManufacturing EngineeringCasting: Patterns, Moulds, Gating and Solidification

A cylindrical blind riser with diameter and height , is placed on the top of the mold cavity of a closed type sand mold as shown in the figure. If the riser is of constant volume, then the rate of solidification in the riser is the least when the ratio is

Figure 1 for GATE 2014 ME Set 3 question 62
  1. A

  2. B

  3. C

  4. D

GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.52 in the ME section

Answer
(A)

From the official answer key published by IIT Kharagpur.

Worked solution

By Chvorinov's rule, the solidification time is . The rate of solidification is the least when is maximum, which corresponds to minimizing the cooling surface area for a given constant volume .

For a top cylindrical blind riser, the bottom surface is in contact with the casting (mold cavity) and does not contribute to heat loss. Hence, the cooling area consists of the cylindrical wall and the top circular face:

The volume of the riser is:

Substitute into the area expression:

To minimize , set :

Thus, the optimal ratio is:

Answer: (A)

Practise Casting: Patterns, Moulds, Gating and Solidification

34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Casting: Patterns, Moulds, Gating and Solidification

Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.