GATE 2014 ME Set 4 · Question 30
Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- A
microstructural changes but does not melt
- B
neither melting nor microstructural changes
- C
both melting and microstructural changes after solidification
- D
melting and retains the original microstructure after solidification
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.20 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In fusion welding, the welded joint consists of three distinct regions:
1. Fusion Zone: The region where base metal and filler metal melt completely and resolidify.
2. Heat Affected Zone (HAZ): The portion of the parent metal that does not melt (), but experiences high temperatures sufficient to alter its microstructure, grain size, and mechanical properties (e.g., grain coarsening, phase transformation).
3. Unaffected Base Metal: The surrounding material that remains metallurgically unaltered.
Therefore, within the HAZ, the material undergoes microstructural changes but does not melt.
Answer: (A) microstructural changes but does not melt
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
- GATE 2024 ME · Q63In an arc welding process, the voltage and current are 30 V and 200 A, respectively. The cross-sectional…
- GATE 2022 ME Set 1 · Q57Two mild steel plates of similar thickness, in butt-joint configuration, are welded by gas tungsten arc…
- GATE 2022 ME Set 2 · Q57In a direct current arc welding process, the power source has an open circuit voltage of 100 V and short…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.