GATE 2015 ME Set 1 · Question 31
Match the following products with preferred manufacturing processes:
| Product | Process |
| :--- | :--- |
| P Rails | 1 Blow molding |
| Q Engine crankshaft | 2 Extrusion |
| R Aluminium channels | 3 Forging |
| S PET water bottles | 4 Rolling |
- A
P-4, Q-3, R-1, S-2
- B
P-4, Q-3, R-2, S-1
- C
P-2, Q-4, R-3, S-1
- D
P-3, Q-4, R-2, S-1
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
We match each component with its typical manufacturing process:
- P. Rails: Heavy structural sections like railway rails are produced by multi-pass hot rolling (4) to achieve the required continuous cross-sectional profile.
- Q. Engine crankshaft: Highly stressed components subject to fatigue and shock loads are made by forging (3) to ensure continuous grain flow and superior fatigue strength.
- R. Aluminium channels: Structural shapes and constant cross-section profiles of ductile metals like aluminium are economically produced by extrusion (2).
- S. PET water bottles: Hollow, thin-walled plastic containers are manufactured by stretch blow molding (1).
Therefore, the correct combination is P-4, Q-3, R-2, S-1.
Answer: (B) P-4, Q-3, R-2, S-1
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
- GATE 2015 ME Set 3 · Q41In a rolling operation using rolls of diameter 500 mm, if a 25 mm thick plate cannot be reduced to less than…
- GATE 2014 ME Set 2 · Q63A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial…
- GATE 2014 ME Set 4 · Q35In a rolling process, the maximum possible draft, defined as the difference between the initial and the…
- GATE 2013 ME · Q10In a rolling process, the state of stress of the material undergoing deformation is
- GATE 2012 ME · Q16A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.