GATE 2012 ME · Question 16
1 markMultiple choiceManufacturing EngineeringBulk Deformation I: Forging and Rolling
A solid cylinder of diameter and height is forged between two frictionless flat dies to a height of . The percentage change in diameter is
- A
0
- B
2.07
- C
20.7
- D
41.4
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
(D)
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
In plastic deformation during forging, the volume of the material remains constant:
Given:
- Initial diameter,
- Initial height,
- Final height,
Solving for the final diameter :
The percentage change in diameter is:
Answer: (D)
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2012 ME · Q38In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness…
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.