GATE 2013 ME · Question 10
In a rolling process, the state of stress of the material undergoing deformation is
- A
pure compression
- B
pure shear
- C
compression and shear
- D
tension and shear
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
During a flat rolling process, the workpiece is gripped and pulled into the deformation zone between two rotating rolls:
1. Compressive stress: The rolls exert high radial forces on the metal strip to reduce its thickness, inducing primary compressive stresses in the thickness and width directions.
2. Shear stress: Friction acts at the roll-strip contact interface (acting towards the neutral point from the entry and opposite from the exit), generating significant shear stresses in the material.
Hence, the material undergoing plastic deformation in the roll gap is subjected to a state of combined compression and shear.
Answer: (C) compression and shear
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2012 ME · Q16A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a…
- GATE 2012 ME · Q38In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness…
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.