GATE 2015 ME Set 3 · Question 41
In a rolling operation using rolls of diameter , if a thick plate cannot be reduced to less than in one pass, the coefficient of friction between the roll and the plate is ______
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
In a flat rolling process, the maximum reduction in plate thickness (maximum draft) that can be achieved in a single pass without external push is related to the roll radius and the coefficient of friction by:
Given data:
- Roll diameter
- Initial thickness
- Minimum final thickness
The maximum draft achieved is:
Substituting the values:
Answer: 0.14
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2014 ME Set 2 · Q63A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial…
- GATE 2014 ME Set 4 · Q35In a rolling process, the maximum possible draft, defined as the difference between the initial and the…
- GATE 2013 ME · Q10In a rolling process, the state of stress of the material undergoing deformation is
- GATE 2012 ME · Q16A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a…
- GATE 2012 ME · Q38In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness…
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.