GATE 2014 ME Set 2 · Question 63
A mild steel plate has to be rolled in one pass such that the final plate thickness is of the initial thickness, with the entrance speed of and roll diameter of . If the plate widens by during rolling, the exit velocity (in ) is \_\_\_\_\_\_
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Assuming incompressibility of the material (constant volume rate) during the rolling process:
where:
- are the initial width, thickness, and entrance velocity, respectively.
- are the final width, thickness, and exit velocity, respectively.
Given data:
Substituting these values into the continuity equation:
Cancelling on both sides:
Answer: 14.71
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2014 ME Set 4 · Q35In a rolling process, the maximum possible draft, defined as the difference between the initial and the…
- GATE 2013 ME · Q10In a rolling process, the state of stress of the material undergoing deformation is
- GATE 2012 ME · Q16A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a…
- GATE 2012 ME · Q38In a single pass rolling process using 410 mm diameter steel rollers, a strip of width 140 mm and thickness…
- GATE 2025 ME · Q41A plate of 30 mm thickness is fed through a rolling mill with two powered rolls. Each roll has a diameter of…
- GATE 2022 ME Set 1 · Q56A 4 mm thick aluminum sheet of width w = 100 mm is rolled in a two-roll mill of roll diameter 200 mm each.…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.