GATE 2015 ME Set 2 · Question 61
During a TIG welding process, the arc current and arc voltage were and , respectively, when the welding speed was . In another process, the TIG welding is carried out at a welding speed of at the same arc voltage and heat input to the material so that weld quality remains the same. The welding current (in A) for this process is
- A
40.00
- B
44.72
- C
55.90
- D
62.25
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The heat input per unit length of the weld is given by:
where is the arc voltage, is the welding current, is the welding speed, and is the arc efficiency.
For identical weld quality, the heat input per unit length must remain constant (). Since the voltage and efficiency are also the same:
Substitute the given values (, , ):
Answer: (A) 40.00
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2014 ME Set 1 · Q32The major difficulty during welding of aluminium is due to its
- GATE 2014 ME Set 4 · Q30Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
- GATE 2024 ME · Q63In an arc welding process, the voltage and current are 30 V and 200 A, respectively. The cross-sectional…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.