GATE 2015 ME Set 1 · Question 41
A DC welding power source has a linear voltage-current (-) characteristic with open circuit voltage of and a short circuit current of . For maximum arc power, the current (in Amperes) should be set as ______
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The linear voltage-current characteristic of a welding power source is given by:
where is the open-circuit voltage and is the short-circuit current.
The arc power is expressed as:
To find the condition for maximum power, differentiate with respect to and set to zero:
Substituting the given value of short-circuit current:
Answer: 150
Practise Welding I: Physics, Power Sources and Arc Welding
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding I: Physics, Power Sources and Arc Welding
- GATE 2015 ME Set 2 · Q61During a TIG welding process, the arc current and arc voltage were 50 A and 60 V, respectively, when the…
- GATE 2014 ME Set 1 · Q32The major difficulty during welding of aluminium is due to its
- GATE 2014 ME Set 4 · Q30Within the Heat Affected Zone (HAZ) in a fusion welding process, the work material undergoes
- GATE 2012 ME · Q39In a DC arc welding operation, the voltage-arc length characteristic was obtained as Varc = 20 + 5l where…
- GATE 2025 ME · Q33During a welding operation, thermal power of 2500 W is incident normally on a metallic surface. As shown in…
- GATE 2024 ME · Q32The most suitable electrode material used for joining low alloy steels using Gas Metal Arc Welding (GMAW)…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.