GATE 2015 ME Set 1 · Question 45
An orthogonal turning operation is carried out under the following conditions: rake angle ; spindle rotational speed ; axial feed and radial depth of cut . The chip thickness, , is found to be . The shear angle (in degrees) in this turning process is _______
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
In an orthogonal turning process, the undeformed chip thickness is related to the feed per revolution by .
Given the spindle speed and axial feed rate :
The chip thickness ratio is:
The shear angle is obtained using Merchant's equation for chip thickness ratio:
Substituting rake angle and :
Answer: 18.88
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2015 ME Set 2 · Q62A single point cutting tool with 0° rake angle is used in an orthogonal machining process. At a cutting…
- GATE 2015 ME Set 3 · Q44Orthogonal turning of a mild steel tube with a tool of rake angle 10° is carried out at a feed of 0.14…
- GATE 2014 ME Set 1 · Q33The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is 400…
- GATE 2014 ME Set 1 · Q62During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the…
- GATE 2014 ME Set 3 · Q30A straight turning operation is carried out using a single point cutting tool on an AISI 1020 steel rod. The…
- GATE 2014 ME Set 3 · Q64Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool? P.…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.