GATE 2016 ME Set 1 · Question 34
In an orthogonal cutting process the tool used has rake angle of zero degree. The measured cutting force and thrust force are and , respectively. The coefficient of friction between the tool and the chip is ____________
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.24 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
In Merchant's circle analysis for orthogonal cutting, the friction force and the normal force at the chip-tool interface are given in terms of the cutting force , thrust force , and orthogonal rake angle by:
The coefficient of friction is defined as:
Given that , , and :
Substituting the given values and :
Answer: 0.5
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2016 ME Set 3 · Q59For an orthogonal cutting operation, tool material is HSS, rake angle is 22°, chip thickness is 0.8 mm,…
- GATE 2015 ME Set 1 · Q45An orthogonal turning operation is carried out under the following conditions: rake angle = 5°; spindle…
- GATE 2015 ME Set 2 · Q62A single point cutting tool with 0° rake angle is used in an orthogonal machining process. At a cutting…
- GATE 2015 ME Set 3 · Q44Orthogonal turning of a mild steel tube with a tool of rake angle 10° is carried out at a feed of 0.14…
- GATE 2014 ME Set 1 · Q33The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is 400…
- GATE 2014 ME Set 1 · Q62During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.