GATE 2016 ME Set 1 · Question 62
2 marksNumerical answerManufacturing EngineeringBulk Deformation I: Forging and Rolling
A thick slab is being cold rolled using roll of diameter. If the coefficient of friction is , the maximum possible reduction (in mm) is _______
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.52 in the ME section
Answer
1.9 to 1.94
From the official answer key published by IISc Bangalore.
Worked solution
In cold rolling, the maximum possible reduction (or draft), , achieved without any external assistance depends on the roll radius and the coefficient of friction :
Given:
- Roll diameter
- Coefficient of friction
Substituting the given values:
Answer: 1.92
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
- GATE 2015 ME Set 3 · Q41In a rolling operation using rolls of diameter 500 mm, if a 25 mm thick plate cannot be reduced to less than…
- GATE 2014 ME Set 2 · Q63A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial…
- GATE 2014 ME Set 4 · Q35In a rolling process, the maximum possible draft, defined as the difference between the initial and the…
- GATE 2013 ME · Q10In a rolling process, the state of stress of the material undergoing deformation is
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.