GATE 2017 ME Set 2 · Question 52
A strip of width and thickness is rolled between two -diameter rolls to get a strip of width and thickness. The speed of the strip at the exit is . There is no front or back tension. Assuming uniform roll pressure of in the roll bite and mechanical efficiency, the minimum total power (in ) required to drive the two rolls is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Given data:
- Roll radius
- Draft
- Width
- Exit strip velocity
- Uniform pressure
The projected contact length is:
The roll separating force is:
For uniform roll pressure, the resultant force acts at the midpoint of contact, giving torque arm . Total torque for two rolls is:
Assuming roll surface velocity is equal to the exit speed :
Answer: 9.6
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
- GATE 2015 ME Set 3 · Q41In a rolling operation using rolls of diameter 500 mm, if a 25 mm thick plate cannot be reduced to less than…
- GATE 2014 ME Set 2 · Q63A mild steel plate has to be rolled in one pass such that the final plate thickness is 2/3rd of the initial…
- GATE 2014 ME Set 4 · Q35In a rolling process, the maximum possible draft, defined as the difference between the initial and the…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.