GATE 2018 ME Set 2 · Question 23
During solidification of a pure molten metal, the grains in the casting near the mould wall are
- A
coarse and randomly oriented
- B
fine and randomly oriented
- C
fine and ordered
- D
coarse and ordered
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.13 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
When molten metal is poured into a mould, heat is rapidly extracted by the cold mould wall, causing severe undercooling at the metal-mould interface.
1. This high degree of supercooling promotes a very high nucleation rate.
2. Because heat is extracted rapidly in all directions at the boundary, many small nuclei form simultaneously with arbitrary crystallographic orientations before directional dendritic growth can dominate.
This produces a narrow outer layer known as the chill zone, consisting of fine and randomly oriented (equiaxed) grains. Deeper inside the casting, the cooling rate drops and preferred growth yields coarse, ordered (columnar) grains.
Answer: (B)
Practise Casting: Patterns, Moulds, Gating and Solidification
34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Casting: Patterns, Moulds, Gating and Solidification
- GATE 2018 ME Set 2 · Q60For sand-casting a steel rectangular plate with dimensions 80 mm × 120 mm × 20 mm, a cylindrical riser has…
- GATE 2017 ME Set 1 · Q54A sprue in a sand mould has a top diameter of 20 mm and height of 200 mm. The velocity of the molten metal…
- GATE 2016 ME Set 1 · Q32The part of a gating system which regulates the rate of pouring of molten metal is
- GATE 2016 ME Set 1 · Q59Heat is removed from a molten metal of mass 2 kg at a constant rate of 10 kW till it is completely…
- GATE 2016 ME Set 1 · Q61A cylindrical job with diameter of 200 mm and height of 100 mm is to be cast using modulus method of riser…
- GATE 2016 ME Set 2 · Q59Gray cast iron blocks of size 100 mm × 50 mm × 10 mm with a central spherical cavity of diameter 4 mm are…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.