PARIXO GATE · ME Open the app

GATE 2016 ME Set 1 · Question 32

1 markMultiple choiceManufacturing EngineeringCasting: Patterns, Moulds, Gating and Solidification

The part of a gating system which regulates the rate of pouring of molten metal is

  1. A

    pouring basin

  2. B

    runner

  3. C

    choke

  4. D

    ingate

GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.22 in the ME section

Answer
(C)

From the official answer key published by IISc Bangalore.

Worked solution

In sand casting, the choke (or choke area) is defined as the minimum cross-sectional area among all components of the gating system (sprue, runner, and ingates).

According to the continuity equation:

where is the choke area and is the flow velocity at the choke. The choke restricts and regulates the volumetric flow rate () of molten metal entering the mold cavity, preventing turbulence and governing the pouring time.

  • The pouring basin receives the molten metal from the ladle and minimizes initial turbulence.
  • The runner channels molten metal from the sprue to the gates.
  • The ingate delivers the metal directly into the mold cavity.

Answer: (C) choke

Practise Casting: Patterns, Moulds, Gating and Solidification

34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Casting: Patterns, Moulds, Gating and Solidification

Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.