GATE 2020 ME Set 1 · Question 56
The thickness of a steel plate with material strength coefficient of , has to be reduced from to in a single pass in a two-high rolling mill with a roll radius of and rolling velocity of . If the plate has a width of and its strain hardening exponent, is , the rolling force required for the operation is ________ *(round off to 2 decimal places)*.
Note:
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.46 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The true strain in the thickness direction during rolling is:
The average flow stress of the material is:
The projected length of contact between the roll and the plate is:
Neglecting friction, the required rolling force is:
Answer: 1167.25
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
- GATE 2015 ME Set 1 · Q47In a slab rolling operation, the maximum thickness reduction (Δ hmax) is given by Δ hmax = μ2 R, where R is…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.