GATE 2021 ME Set 1 · Question 50
A wide plate having a thickness of is fed through a rolling mill with two rolls. The radius of each roll is . The plate thickness is to be reduced to in one pass using a roll speed of . The strength coefficient () of the work material flow curve is and the strain hardening exponent, is . The coefficient of friction between the rolls and the plate is . If the friction is sufficient to permit the rolling operation then the roll force will be ______ *(round off to the nearest integer)*.
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.40 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The draft in the rolling process is:
The projected length of contact () is:
The true strain is:
The average flow stress () of the material is:
Assuming negligible friction effect on roll pressure, the roll force () is:
Answer: 780 (accepts 775 to 784)
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.