GATE 2020 ME Set 1 · Question 42
A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of diameter 200 mm. Coefficient of friction and arc length in mm, respectively are
- A
0.45 and 38.84
- B
0.39 and 38.84
- C
0.39 and 44.72
- D
0.45 and 44.72
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.32 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
Given:
- Initial thickness,
- Final thickness,
- Roll radius,
The draft is:
The projected length of the arc of contact is:
For bite or self-entering condition without external aid, the maximum draft is related to the coefficient of friction by:
Thus, the coefficient of friction is and the arc length is .
Answer: (D) 0.45 and 44.72
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
- GATE 2015 ME Set 1 · Q31Match the following products with preferred manufacturing processes: | Product | Process | | :--- | :--- | |…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.