GATE 2021 ME Set 2 · Question 51
The thickness, width and length of a metal slab are , and , respectively. A rolling operation on this slab reduces the thickness by and increases the width by . The length of the rolled slab is ________ (round off to one decimal place).
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.41 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
Assuming plastic deformation occurs with negligible change in volume (volume constancy):
Given initial dimensions:
- Initial thickness,
- Initial width,
- Initial length,
After rolling:
- Thickness reduction of :
- Width increase of :
Substituting into the volume constancy equation:
Answer: 3883.5
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
- GATE 2017 ME Set 2 · Q52A strip of 120 mm width and 8 mm thickness is rolled between two 300 mm-diameter rolls to get a strip of 120…
- GATE 2016 ME Set 1 · Q62A 300 mm thick slab is being cold rolled using roll of 600 mm diameter. If the coefficient of friction is…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.