GATE 2022 ME Set 1 · Question 56
A thick aluminum sheet of width is rolled in a two-roll mill of roll diameter each. The workpiece is lubricated with a mineral oil, which gives a coefficient of friction, . The flow stress () of the material in is , where is the true strain. Assuming rolling to be a plane strain deformation process, the roll separation force () for maximum permissible draft (thickness reduction) is _______ *(round off to the nearest integer)*.
Use:
contact length, and is the average sheet thickness.
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For a roll radius and coefficient of friction , the maximum permissible draft is:
Thus, the final thickness is:
The true strain is:
The average flow stress is obtained by integrating :
The contact length and average thickness are:
Using the given formula for roll separation force:
Answer: 350
Practise Bulk Deformation I: Forging and Rolling
18 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Bulk Deformation I: Forging and Rolling
- GATE 2021 ME Set 1 · Q50A 200 mm wide plate having a thickness of 20 mm is fed through a rolling mill with two rolls. The radius of…
- GATE 2021 ME Set 2 · Q51The thickness, width and length of a metal slab are 50 mm, 250 mm and 3600 mm, respectively. A rolling…
- GATE 2020 ME Set 1 · Q42A strip of thickness 40 mm is to be rolled to a thickness of 20 mm using a two-high mill having rolls of…
- GATE 2020 ME Set 1 · Q56The thickness of a steel plate with material strength coefficient of 210 MPa, has to be reduced from 20 mm…
- GATE 2020 ME Set 2 · Q32A bolt head has to be made at the end of a rod of diameter d = 12 mm by localized forging (upsetting)…
- GATE 2019 ME Set 2 · Q62The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls.…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.