GATE 2026 ME · Question 30
In relation to metal casting defects, match the following
| Defect | | Description | |
| :--- | :--- | :--- | :--- |
| P | Dross | I | Shallow blow found on a flat casting surface |
| Q | Scab | II | Lighter impurities appearing on the top surface of a casting |
| R | Scar | III | A rough, thin layer of metal, protruding above the casting surface, on top of a thin layer of sand |
- A
P–II, Q–I, R–III
- B
P–II, Q–III, R–I
- C
P–III, Q–II, R–I
- D
P–III, Q–I, R–II
GATE 2026 · Mechanical Engineering · IIT Guwahati
Answer
From the official answer key published by IIT Guwahati.
Worked solution
In sand casting processes:
- Dross (P) consists of naturally occurring oxides and lighter impurities that float and collect at the top surface of the molten metal during pouring, corresponding to (II).
- Scab (Q) is an irregular, rough, thin projection of metal formed when a portion of the mold sand spalls off and liquid metal flows underneath the partially detached sand layer, corresponding to (III).
- Scar (R) is a shallow blow or rounded indentation occurring on a flat casting surface due to trapped gases, corresponding to (I).
Thus, the correct matching is P–II, Q–III, R–I.
Answer: (B) P–II, Q–III, R–I
Practise Casting: Patterns, Moulds, Gating and Solidification
34 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Casting: Patterns, Moulds, Gating and Solidification
- GATE 2025 ME · Q34A liquid metal is poured in a mold cavity of size 200 mm × 200 mm × 200 mm. The cooling is uniform in all…
- GATE 2025 ME · Q38Match the mold elements in the casting process with the most suitable function | Mold element | | Function |…
- GATE 2025 ME · Q62Two metal parts (a cylinder and a cube) of same volume are cast under identical conditions. The diameter of…
- GATE 2024 ME · Q31The allowance provided to a pattern for easy withdrawal from a sand mold is
- GATE 2024 ME · Q61Aluminium is casted in a cube-shaped mold having dimensions as 20 mm × 20 mm × 20 mm. Another mold of the…
- GATE 2023 ME · Q25In a metal casting process to manufacture parts, both patterns and moulds provide shape by dictating where…
Question from the official GATE 2026 ME paper, IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.